Home > News > Content

Dryer Timer Has Two Working Hours

The drying timer is used to set the time for drying clothes. With synchronous micro-motor drive, through the speed reducer gear set, drive two-piece cam rotation, thereby controlling the two pairs of contact A-A1 (Control drying system power), B-B1 (low-temperature drying) action.

Currently used drying timer has two working hours, namely: 0~120min; 0~80min.

When the drying timer works at 0~120min, the two pairs of contacts work simultaneously, the motor and the heater work simultaneously. for drying and heating; When the set time remaining 12min, Dryer Timers the drying timer will cut off the b-b1 contact point, so that the drying system for low-temperature drying.

When the drying timer works in 0~80min, the A-A1 contacts work, the B-B1 contact point does not work, Dryer Timers the system only carries on the low-temperature drying.

Can produce 5 minutes, 10 minutes, 15 minutes, 30 minutes, 60 minutes, 90 minutes, 120 minutes

Product size: 45*43*37mm, 250v/120v,

15A/16A; time error: ±5%;

Operating torque: ≤4.0㎏f. cm;

Return moment: ≤4.0㎏f. cm;

Breakage torsion: 12㎏f-㎝ above;

Durable long life: more than 10,000 times; high temperature: 125 degrees,

Standard working angle: 270 degrees, plus or minus 4 degrees;

Product single weight about $number. 6G

Several points of attention in the use of dryer timer

We are using the drying machine timer to pay attention to the points.

1: Each use, should be planned in advance time, so as not to twist, Dryer Timers increase the timer use time.

2: When rotating the timer, the force should be evenly, do not force too hard, to avoid damage to internal organs.

3: Dryer timer in 0 or full stroke, do not move back and forth, Dryer Timers so as not to damage the plastic positioning file.

4: Although the timer is forced to reverse the function, but in use should try to avoid unnecessary reversals, so as not to damage the machine or reduce service life.

5: Do not push and pull the timer knob, so as to avoid loosening the internal fasteners or dislocation of the mechanical parts, damage timing performance.

6: The timer is soaked by water, to dry the dryer in time. Because the timer although there is leakage prevention measures, but is not a sealed structure, so, after infiltration, easy to cause internal rust, Dryer Timers and the electrical insulation performance reduced.

7: Non-staff do not play with the timer, drying machine, apply cloth cover.

8: Dryer timer out of the trouble, do not move, if not, the situation is worse, Dryer Timers the use of the timer performance. So you must have experienced people or towel dryer manufacturers contact.